REMOVAL & INSTALLATION
| CAUTION | When battery is disconnected, vehicle computer and memory systems may lose memory data. Driveability problems may exist until computer systems have completed a relearn cycle. See COMPUTER RELEARN PROCEDURES article in GENERAL INFORMATION before disconnecting battery. |
Note. Vehicles are designed for starter mounting without shims. A single shim or double shims may have been added to correct a noise or engagement condition. When installing starter, any previously installed shims should be replaced in original location to ensure proper pinion to flywheel clearance.
Remove plastic retainers from clutch pedal position (CPP) switch. Remove CPP switch from push rod. Disconnect CPP switch electrical connector. Remove CPP switch from vehicle. To install, reverse removal procedure.
Removal & Installation (Diesel)
Disconnect negative battery cable. Raise and support vehicle. Disconnect starter solenoid wiring. Remove starter mounting bolts. Remove starter-to-starter bracket nut and washer. Remove starter. To install, reverse removal procedure. Tighten fasteners to specification. See TORQUE SPECIFICATIONS .
Removal & Installation (Gasoline)
Disconnect negative battery cable. Raise and support vehicle. Disconnect starter solenoid wiring. Remove starter motor retaining bolts. Remove shims and note arrangement for reassembly (if equipped). Remove starter. To install, reverse removal procedure. Tighten fasteners to specification. See TORQUE SPECIFICATIONS .