Engine System-General Information: Specifications Ford Taurus IV facelift

General Specifications Table (1 Of 2)

General Specifications Table (1 Of 2)

General Specifications Table (2 Of 2)

General Specifications Table (2 Of 2)

Note. This article contains information, steps and procedures that may not be specific to your engine.

This article covers general procedures and diagnosis and testing of the engine system, except for exhaust emission control devices, which are covered in INTRODUCTION - CNG, FLEX-FUEL & GASOLINE article.

The engine incorporates the following features

1. A closed positive crankcase ventilation (PCV) system. For additional information, refer to «ENGINE EMISSION CONTROL»(ref-212105) .
2. An exhaust emission control system. For additional information, refer to «ENGINE EMISSION CONTROL»(ref-212105) .
3. An evaporative emission control system. For additional information, refer to «EVAPORATIVE EMISSIONS»(ref-212107) .

The engine, fuel system, ignition system, emissions system and exhaust system all affect exhaust emission levels and must be maintained according to the maintenance schedule. Refer to the scheduled Maintenance Guide.

Correct engine identification is required to order parts.

For complete vehicle and engine identification codes, refer to IDENTIFICATION CODES .

Scheme 1

Scheme 2

Scheme 3

Scheme 4

Scheme 5

1. Verify the customer concern by operating the engine to duplicate the condition.
2. Visually inspect for obvious signs of mechanical damage. Refer to the following chart.
3. If the inspection reveals obvious concerns that can be readily identified, repair as necessary.
4. If the concerns remain after the inspection, determine the symptoms. GO to «SYMPTOM CHART»(ref-212097-S13549513342005122300000) .

Scheme 6

Scheme 7

Scheme 8

Scheme 9