Module Configuration System: Other Ford Ranger II рестайлинг

Definition of Terms

The following are definitions of configuration terms

Module Reprogramming

Module reprogramming (also referred to as "flashing") is a scan tool process which updates the strategy/calibration in a module. Reprogramming a module with the same level of software will not improve module operation or repair a hardware failure. Module reprogramming is automatically carried out during PMI when a later strategy/calibration is available.

Note. Module reprogramming should be limited to circumstances where a published TSB procedure recommends doing so.

Note. A module cannot communicate with other modules on the communication network while being reprogrammed. Clear any network communication DTCs which may have been set in other modules during the reprogramming process.

Module Address

A unique module address is assigned to each module on the network for identification.

As-Built Data

As-Built data is a VIN -specific module configuration record. During vehicle build, the configuration from all modules is downloaded and stored in the As-Built database. As-Built data does not reflect customer preference items that have been changed from the default state. These items need to be changed using programmable parameters after the module is configured.

Note. It is not necessary to obtain As-Built data unless directed to do so by the scan tool. This data may be accessed from the technician service publication website.

Module Configuration and Parameter Chart

MODULE CONFIGURATION AND PARAMETER CHART