Inspection and Verification
This article provides step-by-step module configuration procedures. Carry out Programmable Module Installation (PMI) when another workshop information article directs to carry out configuration or when DTCs from the chart are present.
DTC Chart
| DTC | Description | Source | Action |
|---|---|---|---|
| B2477 | Module Configuration Failure | Instrument Cluster (IC) Satellite Digital Audio Receiver System (SDARS) module Smart Junction Box (SJB) | CARRY OUT PMI . REFER to Programmable Module Installation (PMI) . |
| B2477 | Module Configuration Failure | Restraints Control Module (RCM) | INSTALL a new RCM . REFER to SUPPLEMENTAL RESTRAINT SYSTEM . |
| P0602 | Powertrain Control Module Programming Error | PCM | CARRY OUT PMI . REFER to Programmable Module Installation (PMI) . |
| P0605 | Internal Control Module Read Only Memory ( ROM ) Error | PCM | CARRY OUT PMI . REFER to Programmable Module Installation (PMI) . |
| P1639 | Vehicle ID Block Corrupted, Not Programmed | PCM | CARRY OUT PMI . REFER to Programmable Module Installation (PMI) . |
| U0300 | Internal Control Module Software Incompatibility | PCM | CARRY OUT PMI . REFER to Programmable Module Installation (PMI) . |
| U0301 | Software Incompatibility with Engine/Powertrain Control Module | PCM | CARRY OUT PMI . REFER to Programmable Module Installation (PMI) . |
| U2050 | No Application Present | IC Occupant Classification System Module (OCSM) SDARS module SJB 4X4 control module | CARRY OUT PMI . REFER to Programmable Module Installation (PMI) . |
| U2050 | No Application Present | RCM | INSTALL a new RCM . REFER to SUPPLEMENTAL RESTRAINT SYSTEM . |
| U2051 | One or More Calibration Files Missing/Corrupt | RCM | INSTALL a new RCM . REFER to SUPPLEMENTAL RESTRAINT SYSTEM . |
DTC CHART
Programmable Module Installation (PMI) Using the Integrated Diagnostic System (IDS) When the Original Module is Available
Note. Following module installation, some modules require a separate learning procedure be carried out. For adaptive learning and calibration instructions, refer to the specific module removal and installation procedures.
- Connect the IDS and identify the vehicle as normal.
- From the Toolbox icon, select Module Programming and press the check mark.
- Select Programmable Module Installation.
- Select the module that is being replaced.
- Follow the on-screen instructions, turn the ignition key to the OFF position, and press the check mark.
- Install the new module and press the check mark.
- Follow the on-screen instructions, turn the ignition key to the ON position, and press the check mark.
- The IDS downloads the data into the new module and displays Module Configuration Complete.
- Test module for correct operation.
Programmable Module Installation (PMI) Using the Integrated Diagnostic System (IDS) When the Original Module is NOT Available
Note. Following module installation, some modules require a separate learning procedure be carried out. For adaptive learning and calibration instructions, refer to the specific module removal and installation procedures.
- Install the new module.
- Connect the IDS and identify the vehicle as normal.
- From the Toolbox icon, select Module Programming and press the check mark.
- Select Programmable Module Installation.
- Select the module that was replaced.
- Follow the on-screen instructions, turn the ignition key to the OFF position, and press the check mark.
- Follow the on-screen instructions, turn the ignition key to the ON position, and press the check mark.
- If the data is not available, the IDS displays a screen stating to contact the As-Built Data Center. Retrieve the data from the technician service publication website at this time and press the check mark.
- Enter the module data and press the check mark.
- The IDS downloads the data into the new module and displays Module Configuration Complete.
- Test module for correct operation.