REMOVAL
Note. Prior to removal of the SJB, it is necessary to upload module configuration information to a scan tool.
Note. The tire pressure monitoring system (TPMS) functionality is integral to the SJB.
Note. A new SJB module is delivered in manufacturing mode with pre-set DTCs. These DTCs require that the TPMS sensor training procedure be carried out in order for the DTCs to be cleared. The pre-set DTCs are as follows: B2868 - Left Front Tire Pressure Sensor Fault B2869 - Right Front Tire Pressure Sensor Fault B2870 - Right Rear Tire Pressure Sensor Fault B2871 - Left Rear Tire Pressure Sensor Fault C2780 - ECU in Manufacturing Sub-State
- Upload the module configuration information from the SJB. For additional information, refer to «MODULE CONFIGURATION»(ref-268778) article, programmable module installation (PMI).
- Disconnect the battery. For additional information, refer to «BATTERY, MOUNTING AND CABLES»(ref-268774) article.
- Remove the RH lower cowl trim panel. For additional information, refer to «INTERIOR TRIM AND ORNAMENTATION»(ref-268761) article.
- Disconnect the electrical connectors.
- Remove the 3 screws and the SJB.
INSTALLATION
- Install the SJB. Install the 3 screws. Connect the electrical connectors.
- Install the RH lower cowl trim panel. For additional information, refer to «INTERIOR TRIM AND ORNAMENTATION»(ref-268761) article.
- Connect the battery. For additional information, refer to «BATTERY, MOUNTING AND CABLES»(ref-268774) article.
- Download the SJB configuration information from the scan tool. For additional information, refer to «MODULE CONFIGURATION»(ref-268778) article, PMI.
- Carry out TPMS sensor training. For additional information, refer to «WHEELS AND TIRES»(ref-268730) article.