TORQUE SPECIFICATIONS
| Description | Nm |
|---|---|
| Flywheel retaining bolts a |
TORQUE SPECIFICATIONS
a Refer to the appropriate procedure for specifications .
Note. When repairing engines, all parts must be contamination free. If contamination/foreign material is present when repairing an engine, premature engine failure may occur.
Note. Specifications show the expected minimum or maximum condition. Refer to the appropriate Service Information for the procedure.
Note. If a component fails to meet the specifications, it is necessary to refinish it or install a new component. Wear limits are provided as an aid to determine if the component can be refinished. A new component must be installed when any component fails to meet specifications and cannot be refinished.
Note. This article contains information, steps and procedures that may not be specific to this engine.
This article covers general procedures and diagnosis and testing of the engine system, except for exhaust emission control devices, which are covered in the appropriate INTRODUCTION- GASOLINE MODELS article.
The engine incorporates the following features
- Crankcase ventilation or breather system
- Exhaust emission control system
- Evaporative Emission (EVAP) control system Refer to the appropriate Engine article for the procedure.
Some engines incorporate a fail-safe cooling system. Refer to the appropriate Engine article for the procedure.
The engine, fuel system, ignition system, emissions system and exhaust system all affect exhaust emission levels and must be maintained according to the maintenance schedule. Refer to MAINTENANCE SCHEDULE.
Correct engine identification is required to order parts. Refer to the appropriate Engine article for the procedure.
For complete vehicle and engine identification codes, refer to IDENTIFICATION CODES .
SPECIAL TOOLS - ENGINE Illustration Tool Name Tool Number 12 Volt Master UV Diagnostic Inspection Kit 164-R0756 or equivalent (Leak Detector) Dial Indicator Gauge with Holding Fixture 100-002 (TOOL-4201-C) or equivalent Engine Cylinder Leak Detection/Air Pressurization Kit 014-00708 or equivalent EngineEAR 107-R2100 or equivalent EngineEAR/ChassisEAR 107-R2102 or equivalent Oil Pressure Gauge 303-088 (T73L-6600-A) Quick Disconnect Compression Tester 134-R0212 or equivalent Vacuum/Pressure Tester 164-R0253 or equivalent Vehicle Communication Module (VCM) and Integrated Diagnostic System (IDS) software with appropriate hardware, or equivalent scan tool
Scheme 1
Scheme 2
Scheme 3
Scheme 4
| Item | Specification |
|---|---|
| Dye-Lite® Gasoline Engine Oil Leak Detection Dye 164-R3700 (Rotunda) | |
| Motorcraft SAE 5W-20 Premium Synthetic Blend Motor Oil XO-5W20-QSP (US); Motorcraft SAE 5W-20 Super Premium Motor Oil CXO-5W20-LSP12 (Canada); or equivalent | WSS-M2C930-A |
MATERIAL - ENGINE
There are 2 diagnostic paths that can be followed depending on the type of engine concern. Carry out either Inspection and Verification - Engine Performance or Inspection and Verification - Noise, Vibration and Harshness (NVH).