Engine Ignition: Removal & Installation Ford Focus II

Removal and Installation

1. Disconnect the ignition coil-on-plug electrical connector.
2. Remove the bolt and the ignition coil. To install, tighten to 10 Nm (89 lb-in).
3. To install, reverse the removal procedure. Apply silicone dielectric compound to the inside of the ignition coil boot.

Scheme 2

Scheme 3

1. Remove the ignition coil. For additional information, refer to «IGNITION COIL-ON-PLUG»(ref-255425-S32182490182007053100000) .
2. Remove the spark plug. To install, tighten to 12 Nm (9 lb-ft).
3. Inspect the spark plugs.
4. Check and adjust the spark plug gap as necessary.
5. To install, reverse the removal procedure.