Home ReviewsRefund
Home/Ford/Flex/Ford Flex I (2008-2013)/Repair manual/Communication Devices/Electrical Compass - Electronic Compass: Adjustments
Contents Wiring diagrams Section: Communication Devices All sections

Electrical Compass - Electronic Compass: Adjustments Ford Flex I

Communication Devices ~188 words

Compass Zone Adjustment

Note. This procedure is only applicable to vehicles without navigation. For vehicles with navigation, there is no compass zone adjustment.

Pinpoint Test B

B3 FCIM
  1. NOTE: After the FCIM 7 and 9 buttons have been released for approximately 5 seconds, the compass display exits the zone setting mode.

Compass Calibration

Note. This procedure is only applicable to vehicles without navigation. For vehicles with navigation, there is no compass zone adjustment.

Pinpoint Test B

B2 FCIM
  1. NOTE: The vehicle remains in the CAL mode until the compass has been successfully calibrated.
  2. NOTE: While holding the Front Controls Interface Module (FCIM) 7 and 9 buttons down, the compass display first enters the ZONE setting mode (after 5 seconds) and then after another 5 seconds (10 seconds total), the compass display enters the CAL mode.
  3. Press and hold (for approximately 10 seconds) the FCIM 7 and 9 buttons until the CAL indicator appears in the display, then release the buttons.

More articles — Electrical Compass - Electronic Compass