Removal and Installation
| WARNING | Always disconnect the battery ground cable at the battery before disconnecting the starter motor battery terminal lead. If a tool is shorted at the starter motor battery terminal, the tool can quickly heat enough to cause a skin burn. Failure to follow this instruction may result in serious personal injury. |
- With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to «JACKING AND LIFTING»(ref-382368) .
- Disconnect the battery ground cable. For additional information, refer to «BATTERY, MOUNTING AND CABLES»(ref-382392) .
- Remove the starter solenoid wire nut. To install, tighten to 10 Nm (89 lb-in).
- Remove the starter solenoid battery cable nut and the starter motor solenoid wire harness terminal cover. To install, tighten to 10 Nm (89 lb-in).
- Remove the bolts and the starter motor. To install, tighten to 48 Nm (35 lb-ft).
- To install, reverse the removal procedure.