Driveshaft: Removal & Installation Ford Explorer V

Installation

1. If removed, install the center bearing bracket and the 2 inner center bearing bolts. Tighten to 20 Nm (177 lb-in).
2. With the help of an assistant, install the driveshaft and the 2 outer center bearing bracket bolts. Tighten to 30 Nm (22 lb-ft).
3. NOTE: Do not reuse the CV flange bolts. Install new bolts or damage to the vehicle may occur. Install 4 new PTU flange bolts.
4. NOTE: Do not reuse the bolt and washer assemblies for the rear CV joint flange. Install new assemblies or damage to the vehicle may occur. Install 3 new RDU pinion flange bolt and washer assemblies. Tighten to 25 Nm (18 lb-ft).
5. Install the exhaust support brace and the 4 exhaust support brace bolts. Tighten to 30 Nm (22 lb-ft).
6. Install the muffler and tailpipe. REFER to «EXHAUST SYSTEM»(ref-517548) .
7. If a driveshaft is installed and driveshaft vibration is encountered after installation, index the driveshaft. REFER to «DRIVELINE SYSTEM - GENERAL INFORMATION»(ref-517545) .