Home ReviewsRefund
Home/Ford/Explorer/Ford Explorer III (2001-2006)/Repair manual/Charging System/Charging System - Generators & Regulators: Removal & Instal…
Contents Wiring diagrams Section: Charging System All sections

Charging System - Generators & Regulators: Removal & Installation Ford Explorer III

Charging System ~135 words

REMOVAL & INSTALLATION

CAUTIONWhen battery is disconnected, vehicle computer and memory systems may lose memory data. Driveability problems may exist until computer systems have completed a relearn cycle. See COMPUTER RELEARN PROCEDURES article in GENERAL INFORMATION before disconnecting battery.

Removal & Installation (4.0L SOHC)

  1. Disconnect negative battery cable. Remove air cleaner outlet tube. Remove drive belt from generator pulley. Disconnect generator electrical connector. Remove B+ terminal cover, nut and disconnect electrical connector. Remove wire harness retainer.
  2. Remove 2 mounting bolts, stud bolt and generator from vehicle. To install, reverse removal procedure. Tighten fasteners to specification. See «TORQUE SPECIFICATIONS»(ref-139561-S37650092612002050100000) .

Removal & Installation (4.6L SOHC)

  1. Disconnect negative battery cable. Remove drive belt from generator pulley. Disconnect generator electrical connector. Remove B+ terminal cover, nut and disconnect electrical connector. Remove wire harness retainer.
  2. Remove stud bolts and bolts and remove generator bracket. Remove 2 generator mounting bolts and generator from vehicle. To install, reverse removal procedure. Tighten fasteners to specification. See «TORQUE SPECIFICATIONS»(ref-139561-S37650092612002050100000) .

More articles — Charging System - Generators & Regulators