DESCRIPTION & OPERATION
Power windows are operated by reversible type motors mounted with each individual window regulator. Each window has an individual switch for separate control. A master control switch is located on left front door or center console, and all windows may be controlled from this switch.
A lock-out switch is incorporated in master switch. When actuated, it prevents window operation from individual switches. A relay prevents window operation unless ignition switch is in ON or ACC position.
Removal (Window Operational)
- Remove the armrest, door trim panel and watershield. See «DOOR TRIM PANEL»(ref-28362-S00904187862003060400000) .
- Remove door glass. See «DOOR GLASS»(ref-28362-S42636827632003060400000) .
- Disconnect power motor wiring connector.
- Remove 3, 1/4 inch rivets attaching motor bracket to inner panel and 2, 1/4 inch rivets attaching lower bracket of regulator to inner panel. Use drift punch to knock out center pins for each rivet. Using a 1/4 inch diameter drill, drill out remainder of rivet.
- Remove two upper regulator retaining nuts.
- Remove regulator from door.
Installation (Window Operational)
- Lubricate regulator mechanism with Teflon(R) Lubricant D2AZ-19590-A (ESB-M1C111-A), or equivalent.
- Install regulator into access hole in inner panel.
- Position regulator using upper regulator studs and tabs on motor mounting bracket.
- Install rivets attaching regulator to door inner panel (1/4-20 x 1/2 inch screw and 1/4-20 nut and washer assemblies or equivalent metric fasteners may by used as alternates).
- Install 2 upper regulator retaining nuts.
- Install door glass. See «DOOR GLASS»(ref-28362-S42636827632003060400000) .
- Adjust glass, see «ADJUSTMENTS»(ref-28362-S01528751862003060400000) .
- Install watershield and door trim panel.