Home ReviewsRefund
Home/Ford/Escape/Ford Escape I рестайлинг 2 (2007-2012)/Repair manual/Engine Mechanical - 3.0L (4V): Removal & Installation/Installation
Contents Section: Engine Mechanical - 3.0L (4V): Removal & Installation All sections

Installation Ford Escape I рестайлинг 2

Engine Mechanical - 3.0L (4V): Removal & Installation

Installation

  1. Lubricate the crankshaft front seal inner lip with clean engine oil.
  2. Apply silicone gasket and sealant to the end of the keyway slot.
  3. Using the Crankshaft Vibration Damper Installer, install the crankshaft pulley.
  4. Install the bolt and washer. Tighten the bolt in 4 stages: Stage 1: Tighten to 120 Nm (89 lb-ft). Stage 2: Loosen one full turn. Stage 3: Tighten to 50 Nm (37 lb-ft). Stage 4: Tighten an additional 90 degrees.
  5. Install the accessory drive belt. For additional information, refer to «ACCESSORY DRIVE - 3.0L (4V)»(ref-344111) .