- Release fuel pressure. See «FUEL PRESSURE RELEASE»(ref-48376-S24088775892001011500000) . Remove air intake hose, and disconnect accelerator cable. Disconnect necessary coolant hoses, vacuum hoses, and electrical connectors. Remove air intake plenum and gasket.
- Remove fuel rail with fuel injectors and pressure regulator attached. Take care that fuel injectors do not fall from fuel rail. Remove fuel injector grommets from intake manifold. Remove coolant outlet, gasket, and thermostat. Remove distributor, ignition coil, and intake manifold. To install, reverse removal procedure.
Home/Eagle/Summit/Eagle Summit I (1989-1996)/Repair manual/Mechanical/Removal & Installation (Precis): Overview
Contents
Wiring diagrams Section: Mechanical All sections- Abbreviations
- Accessory Drive Belts
- Adjustments
- Anti-Lock/traction Control
- Application
- Automatic Trans
- Auxiliary Emission Control Systems
- Axle Shafts
- Basic Trouble Shooting
- Brakes
- Charging System
- Check Lists
- Clutches Manual & Hydraulic
- Computer Relearn
- Cooling Fan
- Cooling System (Mechanical)
- Cruise Control Systems
- Diagnostic Connector Locations
- Door Locks & Anti-Theft Systems
- Driveline/axles
- Electrical Component Locations
- Emission Applications
- Engine
- Engine Performance
- Fuses & Circuit Breakers
- Gauges & Instrument Panels
- General Servicing - All Makes
- Heated Glass/defoggers
- Heater
- Identification
- Manual & Power Steering
- Manual HVAC System
- Manual Trans
- Mechanical
- Mechanical - Hydraulic
- Metric Conversions
- Oem General Information
- Passive Restraints
- Procedures
- Removal & Installation
- Reset Procedures
- Sensor Range Charts
- Specifications
- Starter
- Steering
- Steering Column
- Steering Column Switches
- Suspension Front
- Suspension Rear
- Testing & Diagnostics
- Theory & Operation
- Timing Belt
- Traction Control Disable
- Transmission
- Wheel Alignment
- Windows
- Wiper/washer Systems
- Wiring Diagrams - Engine Performance