- Install cylinder head. Use new gasket. Ensure identification mark on head gasket is toward timing belt side and faces up. see scheme 6 DO NOT apply sealant to head gasket. Install head bolts and washers. Ensure washers are installed in proper location.
- Tighten bolts to specification in sequence, in 2-3 stages. see scheme 7 To complete installation, reverse removal procedure.
- Apply sealant to rocker cover sealing areas and sealing areas of packing. (Scheme 8) Apply gasoline to "O" ring on fuel line before connecting fuel line to fuel rail. Adjust all control cables.
Contents
Wiring diagrams Section: Mechanical All sections- Abbreviations
- Accessory Drive Belts
- Adjustments
- Anti-Lock/traction Control
- Application
- Automatic Trans
- Auxiliary Emission Control Systems
- Axle Shafts
- Basic Trouble Shooting
- Brakes
- Charging System
- Check Lists
- Clutches Manual & Hydraulic
- Computer Relearn
- Cooling Fan
- Cooling System (Mechanical)
- Cruise Control Systems
- Diagnostic Connector Locations
- Door Locks & Anti-Theft Systems
- Driveline/axles
- Electrical Component Locations
- Emission Applications
- Engine
- Engine Performance
- Fuses & Circuit Breakers
- Gauges & Instrument Panels
- General Servicing - All Makes
- Heated Glass/defoggers
- Heater
- Identification
- Manual & Power Steering
- Manual HVAC System
- Manual Trans
- Mechanical
- Mechanical - Hydraulic
- Metric Conversions
- Oem General Information
- Passive Restraints
- Procedures
- Removal & Installation
- Reset Procedures
- Sensor Range Charts
- Specifications
- Starter
- Steering
- Steering Column
- Steering Column Switches
- Suspension Front
- Suspension Rear
- Testing & Diagnostics
- Theory & Operation
- Timing Belt
- Traction Control Disable
- Transmission
- Wheel Alignment
- Windows
- Wiper/washer Systems
- Wiring Diagrams - Engine Performance
