Home ReviewsRefund
Home/Dodge/Stealth/Dodge Stealth I (1990-1996)/Repair manual/Mechanical/Installation (DOHC)
Contents Wiring diagrams Section: Mechanical All sections

Installation (DOHC) Dodge Stealth I

Mechanical ~168 words
  1. Ensure mating surfaces are clean and dry. Note identification mark located on front of head gasket. Identification marks are "R" for SOHC, 2DN for DOHC non-turbocharged, and 2DT for DOHC turbocharged engine. Install head gasket with identification mark toward timing belt side of engine, facing upward. Align all holes in head gasket.
  2. Install cylinder head. Install cylinder head bolt washers with chamfered side toward bolt head. Using proper sequence, tighten bolts to specification in 2 or 3 stages in sequence. (Схема №5) See «TORQUE SPECIFICATIONS TABLE»(ref-26423-S23399333042001011500000) at the end of this article.
  3. To reinstall camshaft sprocket, hold hexagonal area of camshaft with wrench while tightening sprocket bolt. Tighten rocker cover bolts in a crisscross pattern. Start at 4 corners of rocker cover and work toward center. NOTE: Rocker cover bolts are color-coded. Front cylinder bank bolts are black; rear cylinder bank bolts are green.
  4. To complete installation, reverse removal procedure. Tighten bolts and nuts to specification. See «TORQUE SPECIFICATIONS TABLE»(ref-26423-S23399333042001011500000) at the end of this article.