- To install, reverse removal procedure. Apply sealant to oil pan flange in a continuous.16" (4 mm) diameter bead. (Scheme 21) Install oil pan within 15 minutes of applying sealant.
- Tighten bolts to specification in proper sequence. See TORQUE SPECIFICATIONS TABLE at the end of this article. Wait at least 30 minutes before adding oil and starting engine. On AWD models, refill transfer assembly with GL-4 hypoid gear oil. On all models, complete installation by reversing removal procedure.
Contents
Wiring diagrams Section: Mechanical All sections- Abbreviations
- Accessory Drive Belts
- Adjustments
- Airbag
- Antenna Systems
- Anti-Lock/traction Control
- Application
- Automatic HVAC System
- Automatic Trans
- Auxiliary Emission Control Systems
- Axle Shafts
- Basic Trouble Shooting
- Brakes
- Charging System
- Check Lists
- Clutches Manual & Hydraulic
- Computer Relearn
- Cooling Fan
- Cooling System (Mechanical)
- Cruise Control Systems
- Diagnostic Connector Locations
- Differentials & Drive Axles
- Door Locks & Anti-Theft Systems
- Driveline/axles
- Driveshaft & Universal Joints
- Electrical Component Locations
- Electronic Suspension
- Emission Applications
- Engine
- Engine Performance
- Fuses & Circuit Breakers
- Gauges & Instrument Panels
- General Servicing - All Makes
- Headlight Doors
- Heated Glass/defoggers
- Heater
- Identification
- Manual & Power Steering
- Manual HVAC System
- Manual Trans
- Mechanical
- Mechanical - Hydraulic
- Metric Conversions
- Mirrors
- Oem General Information
- Pin Voltage Charts
- Procedures
- Removal & Installation
- Reset Procedures
- Restraints
- Seats
- Sensor Range Charts
- Specifications
- Starter
- Steering
- Steering Column
- Steering Column Switches
- Sun Roof/t-Top/convertible Top
- Suspension Front
- Suspension Rear
- Testing & Diagnostics
- Theory & Operation
- Timing Belt
- Transmission
- Wheel Alignment
- Windows
- Wiper/washer Systems
- Wiring Diagrams - Engine Performance
