Removal
Remove transaxle/transmission. See appropriate article in TRANSMISSION SERVICING or CLUTCHES. Remove flywheel or drive plate. Remove rear oil seal housing. Pry seal from seal housing.
Installation
Lubricate seal lip with engine oil. Using Seal Driver (MD998718), install seal into seal housing. Apply sealant to sealing surface of seal case. Install seal case. Install flywheel or drive plate. Tighten bolts to specification. See TORQUE SPECIFICATIONS TABLE at the end of this article. To complete installation, reverse removal procedure.
Drain cooling system. Remove timing belt and crankshaft sprocket. See TIMING BELT . Remove coolant ducts to water pump if necessary. Remove water pump bolts, noting length and location for reassembly reference. Remove water pump.
To install, reverse removal procedure, using new gasket and "O" rings. Coat all "O" rings with water before installation. Install water pump and gasket. Tighten bolts to specification. See TORQUE SPECIFICATIONS TABLE at the end of this article.