Home ReviewsRefund
Home/Dodge/Journey/Dodge Journey I (2007-2011)/Repair manual/Body Electrical/Power Distribution: Removal & Installation
Contents Wiring diagrams Section: Body Electrical All sections

Power Distribution: Removal & Installation Dodge Journey I

Body Electrical ~426 words

REMOVAL

Note. When removing or installing the Ignition Off Draw (IOD) fuse, it is important that the ignition switch be in the OFF position. Failure to place the ignition switch in the OFF position can cause the radio display to become scrambled when the IOD fuse is installed. Removing and installing the IOD fuse again with the ignition switch in the OFF position will usually correct the scrambled radio display condition.

  1. Turn the ignition switch to the OFF position.
  2. Remove the cover from the Totally Integrated Power Module (TIPM).
  3. Pull on IOD fuse (J13) holder until it reaches the first detent.

INSTALLATION

  1. Push on IOD fuse until completely seated.
  2. Install the cover to the Totally Integrated Power Module (TIPM).
  1. Position the inverter into the vehicle and install mounting fasteners.
  2. Connect the electrical connectors.
  3. Connect the battery negative cable.
  4. Position the front drivers seat back to the original position.
  1. Open hood.
  2. Disconnect and isolate the battery negative cable.
  3. Release the Totally Integrated Power Module (TIPM) cover retaining clips and open the TIPM cover.
  4. Remove the TIPM positive cable retaining nut and remove the cable from the stud.
  5. Depress the four mounting clips to disengage and remove the TIPM housing from its mounting bracket.
  6. Disconnect each of the seven TIPM wire harness connectors.
  7. Remove the TIPM from the vehicle.
CAUTIONThe original Cabin Compartment Node (CCN) and Powertrain Control Module (PCM) must be installed and functioning properly prior to powering up the new Totally Integrated Power Module (TIPM). The TIPM receives vehicle configuration data from the CCN and Vehicle Identification Number (VIN) information from the PCM. If configuration information becomes lost or corrupted, the data can be obtained from DealerCONNECT
  1. Position the TIPM into the engine compartment.
  2. Connect each of the seven TIPM wire harness connectors.
  3. Position the TIPM onto the mounting bracket and push down until the mounting clips are fully seated.
  4. Position the TIPM positive cable onto the mounting stud and install the retaining nut. Tighten the nut to 9 - 11 N.m (80 - 100 in. lbs.).
  5. Open the TIPM cover and fully seat the airbag fuse holder (two fuses in one yellow carrier) and the Ignition Off Draw (IOD) fuse.
  6. Connect the battery negative cable.
  7. Close the hood.
  8. Insert the ignition key and turn it to the RUN position and wait twelve seconds. The TIPM will collect the necessary vehicle configuration and VIN data from the CCN and PCM at this time. After twelve seconds turn the ignition key to the OFF position and then back to the ON position and verify proper vehicle systems operation.
  1. Disconnect and isolate the battery negative cable.
  2. Using Power Outlet Remover 9857 (4). Insert the tool with tips against bosses (1).
  3. Pull out the base (3) through mounting ring by gently rocking power outlet remover.
  4. Disconnect the base wires (2).
  1. Connect wire harness connectors.
  2. Install power outlet to instrument panel.
  3. Connect battery negative cable.

More articles — Power Distribution