TROUBLE SHOOTING
Inspect power window circuit breaker (25-amp), located in left kick panel. Inspect fuse No. 28 (40-amp) in Intelligent Power Module (IPM). IPM is located on left side of engine compartment. Inspect ground at right "B" pillar.
WIRING VOLTAGE TEST
- Remove the power window switch and bezel assembly from the driver door. See «POWER WINDOW SWITCH»(ref-160200-S42220928352004020300000) under REMOVAL & INSTALLATION.
- Disconnect wire connector from back of power window switch.
- Turn ignition switch to ON position.
- Connect the clip end of a 12-volt test light to pin No. 13 in door harness connector at the window switch. Touch the test light probe in pin No. 9 and then to pin No. 11. If the test light illuminates, the wiring circuit between the battery and switch is OK. If the lamp does not illuminate, first check the 25-amp circuit breaker attached to the electrical distribution wiring bracket. If the circuit breaker is OK, then check the 40-amp fuse No. 28 in the Integrated Power Module (IPM). If both components are OK, then check for a broken wire. See «WIRING DIAGRAMS»(ref-160200-S02538106282004020300000) .