Home/Chrysler/Crossfire/Chrysler Crossfire I final (2008-2008)/Repair manual/Nag1 Automatic Transmission - Electrical Diagnostics/P0702-CONTROL MODULE TCM IS NOT CODED

Contents

Section: Nag1 Automatic Transmission - Electrical Diagnostics

DIAGNOSTIC CODE INDEX

Diagnostic Test

1000-03 SLA INTERNAL FAILURE

1000-04 SLA INTERNAL FAILURE

When Monitored and Set Condition

1817-02 REVERSE LAMP CIRCUIT SHORT TO VOLTAGE

1817-03 REVERSE LAMP SUPPLY CIRCUIT OPEN

1832-00 SLA INTERNAL FAILURE

1833-00 SLA INTERNAL FAILURE

1856-01 SLA INTERNAL FAILURE

1856-02 SLA INTERNAL FAILURE

1856-03 SLA INTERNAL FAILURE

1856-04 SLA INTERNAL FAILURE

1856-05 SLA INTERNAL FAILURE

1856-06 SLA INTERNAL FAILURE

1861-00 LR WHEEL SPEED CAN NOT VALID

1876-00 INCORRECT CAN MESSAGE FROM ABS

1910-00 SLA SYSTEM OVERVOLTAGE

1912-01 SLA INTERNAL FAILURE

1912-02 SLA INTERNAL FAILURE

P0563-SYSTEM OVERVOLTAGE

P0600-ABS CAN MESSAGE INCORRECT

P0600-ABS LEFT FRONT SENSOR MESSAGE

P0600-ABS LEFT REAR SENSOR MESSAGE

P0600-ABS RIGHT FRONT SENSOR MESSAGE

P0600-ABS RIGHT REAR SENSOR MESSAGE

P0600-ACCEL PEDAL SENSOR CAN MESSAGE INCORRECT

P0600-CAN COMMUNICATION INCORRECT

P0600-CAN COMMUNICATION LENGTH INCONSISTENT

P0600-ENGINE CAN MESSAGE INCORRECT

P0600-ENGINE RPM MESSAGE

P0600-ENGINE TEMPERATURE MESSAGE

P0600-ENGINE TORQUE MESSAGE INCORRECT

P0600-SLA CAN MESSAGE INCORRECT

P0700-TRANSMISSION SLIPPING

P0702-CONTROL MODULE TCM IS NOT CODED

P0702-INTERNAL CONTROLLER

P0702-INVALID CONTROL MODULE VERSION

P0715-INPUT SENSOR MISMATCH

P0715-INPUT SENSOR OVERSPEED

P0730-IMPROPER GEAR

P0730-IMPROPER RATIO

P0740-TCC OVERTEMP

P0743-TCC SOLENOID CIRCUIT

Theory of Operation

P0758-2-3 SOLENOID CIRCUIT

P0763-3-4 SOLENOID CIRCUIT

P0778-SOLENOID SUPPLY VOLTAGE

P0850-TRANS TEMP SENSOR - P/N SWITCH CIRCUIT

P1793-ENGINE TORQUE REDUCTION

NAG1 TRANSMISSION VERIFICATION TEST

All sections

P0702-CONTROL MODULE TCM IS NOT CODED Chrysler Crossfire I final

Nag1 Automatic Transmission - Electrical Diagnostics

P0702-CONTROL MODULE TCM IS NOT CODED

When Monitored: With the ignition on.
Set Condition: The TCM has not been coded.

Possible Causes
TRANSMISSION CONTROL MODULE NOT CODED

For a complete Transmission Control Module Circuit Diagram, see SCHEMATICS AND DIAGRAMS .

1) TRANSMISSION CONTROL MODULE NOT CODED The Transmission Control Module was not coded and must be replaced. View repair. Repair Replace the Transmission Control Module. Refer to «REMOVAL»(/chrysler/crossfire/i-final-2008-2008/remont/communication-devices/#electronic-control-modules-service-information) . Perform «NAG1 TRANSMISSION VERIFICATION TEST»(/chrysler/crossfire/i-final-2008-2008/remont/automatic-trans/#nag1-automatic-transmission-electrical-diagnostics__nag1-transmission-verification-test) .