P0600-ABS LEFT FRONT SENSOR MESSAGE Chrysler Crossfire I final

P0600-ABS LEFT FRONT SENSOR MESSAGE

1. When Monitored: Valid ABS CAN messages received at least once and the CAN BUS Circuit, ABS CAN Message Missing, ABS CAN Message Incorrect are not active.
2. Set Condition: Wheel Speed Front Left signal not valid or CAB has detected a sensor failure.

For a complete Transmission Control Module Circuit Diagram, see SCHEMATICS AND DIAGRAMS .

For a complete CAN BUS Circuit Diagram, refer to SCHEMATICS AND DIAGRAMS .

1. 1) PRE-DIAGNOSTIC CHECK OUT NOTE: Low fluid level can be the cause of many transmission problems. If the fluid level is low, locate and repair the leak then check and adjust the fluid level in accordance with the Service Information. NOTE: Always perform diagnostics with a fully charged battery to avoid false symptoms. With the scan tool, read Engine DTCs. Check and repair all engine DTCs prior to performing transmission symptom diagnostics. With the scan tool, read and record all Transmission DTCs. NOTE: Check connectors - Clean/repair as necessary. Poor pin to terminal connections can set DTCs. Using the wiring diagram/schematic as a guide, inspect the wiring and connectors. Repair as necessary. Most DTCs set on start up but some must be set by driving the vehicle such that all diagnostic monitors have run. NOTE: Check for any Technical Service Bulletins that may apply. Perform this procedure prior to Symptom diagnosis. Continue Go to step 2) .
2. 2) (P0720) CAN BUS CIRCUIT DTC PRESENT Turn the ignition on. With the scan tool, read Transmission DTCs. NOTE: If DTC (P0720) CAN BUS CIRCUIT is present, perform diagnostics on that symptom first. Is DTC (P0720) CAN BUS CIRCUIT present? Yes Diagnose appropriate DTC. No Go to step 3) .
3. 3) CHECK TO SEE IF ABS DTCS ARE PRESENT With the ignition on. With the scan tool, read ABS DTCs. Are any ABS DTCs present? Yes Diagnose appropriate DTC. No Go to step 4) .
4. 4) CONTROLLER ANTILOCK BRAKE Turn the ignition off. Replace the Controller Antilock Brake. Refer to «REMOVAL»(/chrysler/crossfire/i-final-2008-2008/remont/communication-devices/#electronic-control-modules-service-information) . Turn the ignition on. With the scan tool, erase Transmission DTCs. Road test the vehicle. With the scan tool, read Transmission DTCs. Did DTC (P0600) ABS LEFT FRONT SENSOR MESSAGE set again? Yes Replace the Transmission Control Module. Refer to «REMOVAL»(/chrysler/crossfire/i-final-2008-2008/remont/communication-devices/#electronic-control-modules-service-information) . Perform «NAG1 TRANSMISSION VERIFICATION TEST»(/chrysler/crossfire/i-final-2008-2008/remont/automatic-trans/#nag1-automatic-transmission-electrical-diagnostics__nag1-transmission-verification-test) . No Test Complete.