FLUID CAPACITIES
The following refill capacities given are approximate. Correct fluid level should always be determined by marks on dipstick, rather than amount of fluid added. DO NOT overfill. See TRANSMISSION FLUID CAPACITIES table.
| Application | Capacity - Qts. (L) |
|---|
| Pan Removal | 5.0 (4.7) |
| Overhaul | 11.0 (10.6) |
| Dry Fill (1) |
| 245-mm Torque Converter | 8.8 (8.3) |
| 258-mm Torque Converter | 9.3 (8.8) |
| 298-mm Torque Converter | 11.9 (11.25) |
| 300-mm Torque Converter | 12.1 (11.5) |
| (1) Capacities listed are approximate. |
| (1) | Capacities listed are approximate. |
TRANSMISSION FLUID CAPACITIES
TORQUE SPECIFICATIONS
| Application | Ft. Lbs. (N.m) |
|---|
| Heat Shield Bolt | 13 (18) |
| Lower Support Mounting Bolts | 37 (50) |
| Mount-To-Support Retaining Nuts | 35 (46) |
| PNP Switch Bolt | 18 (24) |
| Shift Cable Bracket Bolt | 18 (24) |
| Transmission Control Lever Nut | 18 (24) |
| Transfer Case Fill & Drain Plug | 20 (27) |
| Transmission Fluid Drain Plug | 13 (18) |
| Upper Support Mounting Bolts | 59 (80) |
| INCH Lbs. (N.m) |
| Accumulator-To-Case Bolt | 97 (11) |
| Filler Tube Bolt | 89 (10) |
| Manual Detent Spring Bolt | 97 (11) |
| Oil Cooler Line Bolt | 97 (11) |
| Oil Pan Bolt | 97 (11) |
| Oil Pass Cover Bolt | 97 (11) |
| Pressure Control Solenoid Bolt | 97 (11) |
| TCC Solenoid Bolt | 97 (11) |
| Transmission Fluid Indicator Stop Bolt | 97 (11) |
| Valve Body-To-Case Bolt (1) | 97 (11) |
| VSS Bolt | 97 (11) |
| (1) Tighten valve body bolts in a spiral pattern starting in center of valve body. |
| (1) | Tighten valve body bolts in a spiral pattern starting in center of valve body. |
