ELECTROMAGNETIC INTERFERENCE & ELECTRICAL NOISE
Some electrical components or circuits are sensitive to Electromagnetic Interference (EMI) or other types of electrical noise. Perform the following procedures
- Inspect for a misrouted harness that is too close to a high voltage or high current device. This condition may induce electrical noise on a circuit that could interfere with normal circuit operation. Inspect for wires that are too close to the following devices: Secondary ignition components. Motors. The generator.
- Determine whether the electrical system interference is caused by a malfunctioning relay, PCM driven solenoid or switch. These components may cause a sharp electrical surge. Normally, the problem will occur when the malfunctioning component is operating.
- Determine whether non-factory or aftermarket add-on accessories are installed in the vehicle. These accessories may lead to an emission related OBD-II failure. Determine if any of the following non-factory or aftermarket add-on accessories is causing the intermittent: Lights. 2-way radios. Amplifiers. Electric motors. Remote starters. Alarm systems. Cellular phones.
- Test for an open diode across the A/C compressor clutch and for other open diodes. Some relays may contain a clamping diode.
- Test for proper performance of the generator. See ON-VEHICLE TESTING in appropriate GENERATORS & REGULATORS article in STARTING & CHARGING SYSTEMS.
- If a DTC is determined to be intermittent and the tests do not reveal a problem, see «VEHICLE DATA RECORDER»(ref-152982-S38320382482003030700000) .