OIL COOLER FLUSHING
- If available, fill line flusher with solution and install Oil Cooler and Line Flusher (J-35944) to top transaxle cooler line on transaxle. Follow manufacturer's instructions to flush oil cooler and cooler lines.
- If flusher tool is not available, flush cooler and cooler lines with a mixture of clean solvent and water. Flush cooler in both directions until all old fluid and debris are removed. If necessary, replace plugged or damaged cooler and/or lines.
Fluid Out Of Vent Or Foaming
Transmission overfilled. Fluid contaminated with antifreeze or engine overheating. Filter not seated. Cross-channel leak allowing pressure to leak in to vent area of pump cover.
Reduced Internal Lubrication
Cross channel leakage in pump cover. Pressure regulator stuck in high demand. Damaged oil pump mounting gasket. Stuck closed converter limit valve assembly (under heavy load).