Remote Start Calibration, (if equipped)
In order to setup the remote start feature a Techline Terminal using the Pass-Thru routine must be used. With the scan tool powered down, attach it to the vehicle then connect the Techline Terminal's RS-232 cable to the scan tool. Select Service Programming System from the Techline Terminal main screen. Select the Pass-Thru procedure from the Techline Terminal's menu selections and follow all on-screen directions. Ensure the correct programming procedure is selected based on the component being replaced or programmed. Configure the remote start feature to match the original RPO content on the vehicle. See Service Programming System (SPS) .
BPP Sensor Calibration
| IMPORTANT | If the BCM or the brake apply sensing system (BAS) sensor is replaced, a BPP sensor calibration must be performed. |
Perform the BPP Sensor Calibration using a scan tool. Refer to LIGHTING , for the BPP calibration procedure.
Steering Position Sensor Calibration
- Install the scan tool.
- Turn ON the ignition, with the engine OFF.
- Center the steering wheel.
- With the scan tool select Special Functions.
- Select Steering Position Sensor Calibration and press the Enter key. The scan tool screen will flash Calibration in Progress then display Calibration Complete.
- Press the exit key.
- Use the scan tool in order to clear any EPS DTCs. IMPORTANT: After turning OFF the ignition, allow 25 seconds of wait time before performing any procedures that require the vehicles battery to be disconnected, or module memory loss may occur.
- Turn OFF the ignition.