Home ReviewsRefund
Home/Chevrolet/Malibu/Chevrolet Malibu VI (2003-2006)/Repair manual/Automatic Transaxle - 4t40-e/4t45-e - Introduction, Service & Replacement/Removal Procedure
Contents Wiring diagrams Section: Automatic Transaxle - 4t40-e/4t45-e - Introduction, Service & Replacement All sections

Removal Procedure Chevrolet Malibu VI

Automatic Transaxle - 4t40-e/4t45-e - Introduction, Service & Replacement ~121 words

Removal Procedure

  1. Disconnect the negative battery cable.
  2. Remove the console. Refer to «Console Replacement»(/chevrolet/malibu/vi-2003-2006/remont/gauges-instrument-panels/#instrument-panel-system-displays-gauges-and-console) in Instrument Panel, Gages and Console.
  3. Remove the left sound insulator. Refer to «Closeout/Insulator Panel Replacement - Left»(/chevrolet/malibu/vi-2003-2006/remont/gauges-instrument-panels/#instrument-panel-system-displays-gauges-and-console) in Instrument Panel, Gages and Console.
  4. Remove the knee bolster.
  5. Place the transmission shift lever in the P (Park) position.
  6. Turn the ignition key to the RUN position.
  7. Insert a screwdriver blade into the slot provided in the ignition switch inhibitor.
  8. Depress the cable latch. Pull the control cable from the inhibitor.
  9. Push the cable connector lock button at the shifter base to the up position.
  10. Snap the cable from the park/lock lever pin.
  11. Depress the two cable latches. Remove the control cable from the transmission control.