Home ReviewsRefund
Home/Cadillac/STS/Cadillac STS I (2004-2007)/Repair manual/Communication Devices/Computer/integrating Systems: Removal & Installation
Contents Wiring diagrams Section: Communication Devices All sections

Computer/integrating Systems: Removal & Installation Cadillac STS I

Communication Devices ~248 words

Removal Procedure

  1. Remove the instrument panel compartment. Refer to «Compartment Replacement - Instrument Panel (I/P)»(ref-197555-S41910413392005101200000) in Instrument Panel, Gages, and Console.
  2. Remove the screws securing the dash integration module to the module bracket.
  3. Disconnect the electrical connectors.

Installation Procedure

  1. Connect the electrical connectors.
  2. Install the module to the bracket.
  3. Install the screws that secure the module to the bracket. Tighten: Tighten the screws to 2 N.m (18 lb in).
  4. Install the instrument panel compartment. Refer to «Compartment Replacement - Instrument Panel (I/P)»(ref-197555-S41910413392005101200000) in Instrument Panel, Gages, and Console.
  5. Reprogram the module. Refer to «Control Module References»(ref-197535-S32949592342005101200000) .
  1. Remove the rear upper compartment trim. Refer to «Compartment Trim Panel Replacement - Rear»(ref-197543-S21104577462005101200000) in Body Rear End.
  2. Release the tabs securing the rear integration module (2) to the module bracket.
  3. Disconnect the electrical connectors.
  1. Connect the electrical connectors.
  2. Install the module (2) to the bracket.
  3. Install the rear upper compartment trim. Refer to «Compartment Trim Panel Replacement - Rear»(ref-197543-S21104577462005101200000) in Body Rear End.
  4. Reprogram the module. Refer to «Control Module References»(ref-197535-S32949592342005101200000) .
  1. Remove the knee bolster trim. Refer to «Knee Bolster Replacement»(ref-197555-S26192190472005101200000) in Instrument Panel, Gages, and Console.
  2. Remove the screws (1) securing the data link connector to the instrument panel (I/P).
  1. Locate the connector to the I/P.
  2. Install the screws (1) securing the connector to the I/P. Tighten: Tighten the screws (1) to 2 N.m (18 lb in).
  3. Install the knee bolster trim. Refer to «Knee Bolster Replacement»(ref-197555-S26192190472005101200000) in Instrument Panel, Gages, and Console.

More articles — Computer/integrating Systems