FASTENER TIGHTENING SPECIFICATIONS
| Component | Bolt Size | Nm |
|---|---|---|
| Bracket for Oil Cooler | 15 | |
| Chain Sprocket 1 | 20 + 90° | |
| Chain Tensioner with Tensioning Rail | 15 | |
| Oil Baffle | 9 | |
| Oil Drain Plug | 30 | |
| Oil Filter Bracket | 15 | |
| Oil Intake Pipe | 8 | |
| Oil Level Thermal Sensor | 9 | |
| Oil Pressure Switch | 21 | |
| Oil Pump Cover | 8 | |
| Oil Return Pipe | 9 | |
| 1 Replace | ||
Oil Pan - Tightening Specifications and Sequence
Tighten the oil pan bolts in three stages as follows
Tighten the bolts from the oil pan to the cylinder block -1 to 20- in a diagonal sequence to 5 Nm.
Tighten the bolts from the oil pan to the transmission -arrows- to 40 Nm.
Tighten the bolts from the oil pan to the cylinder block -1 to 20- in a diagonal sequence to 15 Nm.
Oil Dipstick Guide Tube - Tightening Specifications
Tighten the double bolt -arrow- to 6 Nm.
Balance Shaft Housing Bolts
A - Collar bolt M7x40
B - Collar bolt M7x70
C - Collar bolt M7x90
D - Collar bolt M7x55
E - Sealing plug with O-ring
Balance Shaft Housing - Tightening Specifications and Sequence
Replace the balance shaft housing bolts -arrows-.
Tighten bolts in 3 stages as follows
Install bolts by hand as far as the stop.
Tighten to 15 Nm in a diagonal sequence from inside to outside.
Tighten an additional 90° in a diagonal sequence from inside to outside.