FASTENER TIGHTENING SPECIFICATIONS
| Component | Bolt Size | Nm |
|---|---|---|
| Chain Tensioner | 9 | |
| Engine Oil Cooler | 23 | |
| Oil Baffle | 9 | |
| Oil Drain Plug 1 | 30 | |
| Oil Level Thermal Sensor, Nut | 9 | |
| Oil Pressure Regulation Valve | 9 | |
| Oil Pressure Switch | 20 | |
| Oil Pump | ||
| M6 | 9 | |
| M8 | 20 | |
| Reduced Oil Pressure Switch | 20 | |
| Suction Line | 9 | |
| 1 Always replace | ||
Lower Oil Pan, Tightening Sequence
Tighten bolts in 3 stages in -1 to 20- sequence as follows
| Tighten bolts by hand.-- Tighten the bolts to 8 Nm.-- Tighten the bolts an additional 45°. |
Upper Oil Pan, Tightening Sequence
Tighten bolts in 3 stages in -1 to 14- sequence as follows
Note. There may be 13 bolts installed, depending on the version.
| Tighten bolts by hand.-- Tighten the bolts to 15 Nm.-- Tighten the bolts an additional 90°. |
Oil Separator, Tightening Sequence
Tighten the bolts to 9 Nm in the following sequence: -1 to 9-.
See also:
• 03 MAINTENANCE, DIAGNOSIS