Install oil pump in reverse order of removal but note the following
Sealing surface must be free of oil or sealing compound.
- Clean sealing surfaces with electric drill and plastic brush insert.
| CAUTION | Wear eye protection. |
Scheme 79
Note. Oil pan must be installed within 5 minutes of applying silicone sealer D 176 404 A2.
- Cut off nozzle of tube at front marking (nozzle dia. approx. 3 mm or 5/16 in.). Thickness of sealant bead: 2 to 3 mm (approx. 1/8 in.)
| CAUTION | Part numbers are listed for reference only. Always check with your Parts department for the latest information. |
Scheme 80
Note. The bead of sealant must not be thicker than 3 mm (approx. 1/8 in.), as otherwise excess sealant will enter the oil pan and obstruct the strainer in the oil intake pipe.
- Install oil pan immediately and tighten all bolts to initially 5 Nm (44 in. lb).
- Tighten bolts in crosswise sequence - final torque: 15 Nm (11 ft lb).
- Replace seal on oil drain plug and tighten to 30 Nm (22 ft lb).
Note. After installing the oil pan, wait for about 30 minutes for the sealant to cure before filling with engine oil.
- Fill with engine oil.