Component Layout Audi S6 C5

Note. Always replace gaskets and seals.

The following list pertains to (Схема №202).

1. Oil pan - lower section
2. 10 Nm (7 ft lb)
3. Oil pan - upper section
4. 10 Nm (7 ft lb)
5. Grid section
6. Circlip
7. Rubber tube
8. Strainer
9. Oil pump Removing, see «OIL PUMP, REMOVING»(ref-196260-S33448624402005100700000) . If faulty, always replace whole pump
10. 25 Nm (18 ft lb)
11. Baffle plate
12. Oil level sensor
13. 35 Nm (26 ft lb)
14. 25 Nm (18 ft lb)
15. 10 Nm (7 ft lb)
16. 25 Nm (18 ft lb)
17. 60 Nm (44 ft lb) + additional 90° Apply sealant D 454 300 02 before inserting ALWAYS REPLACE BOLTS
18. Plate
19. Drive plate When assembling, make sure that dowel for ignition timing is correctly inserted in drive plate. Dowel should project 20 - 22 mm (0.78 to 0.86 in.) from drive plate
20. 10 Nm (7 ft lb)
21. Rear sealing flange with oil seal