SEQUENCE AND BRAKE FLUID CAPACITY TABLE
| Left front | 200 ml |
|---|---|
| Right front | 200 ml |
| Left rear | 200 ml |
| Right rear | 200 ml |
| Total amount (1) | 1000 ml |
| (1) Including brake fluid extracted from brake fluid reservoir and quantity from clutch slave cylinder. | |
| (1) | Including brake fluid extracted from brake fluid reservoir and quantity from clutch slave cylinder. |
Install cover caps on brake caliper bleeder screws.
Move filler lever on VAS 5234 or V.A.G 1869 to position -B- (see operating instructions).
Remove the filler hose from the adapter.
Remove the adapter from the brake fluid reservoir.
Check brake fluid level and fill if necessary.
Install the brake fluid reservoir cap.
Check pedal pressure and brake pedal free play. Free play: max 1 / 3 of pedal travel
WHEEL BOLTS TIGHTENING SPECIFICATIONS
Wheel Bolts
The adapter to loosen/tighten the anti-theft wheel bolts is located with the vehicle tool kit.
Note. Be sure to tighten wheel bolts in diagonal sequence to the following specified torque
| Tightening Specifications | Nm |
|---|---|
| Wheel Bolts | 120 |
Place the adapter and extractor back in the vehicle tool kit.
TIGHTENING SPECIFICATIONS
| Component | Nm |
|---|---|
| Electrical wiring guide for ignition coils to cylinder head cover | 5 |
| Spark plugs in cylinder head | 30 |
| Component | Nm |
|---|---|
| Electrical wiring guide for ignition coils to cylinder head cover | 5 |
| Spark plugs in cylinder head | 30 |
Installation is the reverse of removal.
Edition 05112012JY