Home ReviewsRefund
Home/Audi/S5/Audi S5 I facelift (2011-2016)/Repair manual/Procedures/Maintenance, Diagnosis - Maintenance Procedures (Coupe): Sp…
Contents Wiring diagrams Section: Procedures All sections

Maintenance, Diagnosis - Maintenance Procedures (Coupe): Specifications Audi S5 I facelift

Procedures ~132 words

SEQUENCE AND BRAKE FLUID CAPACITY TABLE

Left front200 ml
Right front200 ml
Left rear200 ml
Right rear200 ml
Total amount (1)1000 ml
(1) Including brake fluid extracted from brake fluid reservoir and quantity from clutch slave cylinder.
(1)Including brake fluid extracted from brake fluid reservoir and quantity from clutch slave cylinder.

Install cover caps on brake caliper bleeder screws.

Move filler lever on VAS 5234 or V.A.G 1869 to position -B- (see operating instructions).

Remove the filler hose from the adapter.

Remove the adapter from the brake fluid reservoir.

Check brake fluid level and fill if necessary.

Install the brake fluid reservoir cap.

Check pedal pressure and brake pedal free play. Free play: max 1 / 3 of pedal travel

WHEEL BOLTS TIGHTENING SPECIFICATIONS

The adapter to loosen/tighten the anti-theft wheel bolts is located with the vehicle tool kit.

Note. Be sure to tighten wheel bolts in diagonal sequence to the following specified torque

Tightening SpecificationsNm
Wheel Bolts120

Place the adapter and extractor back in the vehicle tool kit.

See also:
• Maintenance, Diagnosis

More articles — Maintenance, Diagnosis - Maintenance Procedures (Coupe)