FASTENER TIGHTENING SPECIFICATIONS
| Component | Fastener Size | Nm |
|---|---|---|
| Bracket for EVAP Canister Purge Regulator Valve 1 | 9 | |
| Cap for Oil Filter Housing | 25 | |
| Cover | 9 | |
| Hose for Crankcase Ventilation | 9 | |
| Intake Tube for Oil Pump | ||
| Oil Baffle | 9 | |
| Oil Check Valve Housing | 9 | |
| Oil Drain Plug | 25 | |
| Oil Filter Housing 2 | ||
| 9 | ||
| 22 | ||
| Drain Plug | 9 | |
| Drain Plug | 50 | |
| Oil Level Thermal Sensor, Nut | 9 | |
| Oil Pan (upper section) Locking Bolt | 35 | |
| Oil Pipe | 9 | |
| Oil Pump 1 | 8 + 90° | |
| 1 Always replace 2 For bolt tightening clarification, refer to OIL FILTER HOUSING OVERVIEW and see items -2, 4, 11 and 12 | ||
OIL COOLER TIGHTENING SPECIFICATIONS AND SEQUENCE
Note. Replace the gaskets -3- for the oil cooler -2-.
Tighten bolts in 2 stages as follows
| Stage | Bolts | Tightening Specifications |
|---|---|---|
| 1. | 1 | 3 Nm |
| 2. | 1 | 9 Nm |
OIL PRESSURE SWITCH -F1- - TIGHTENING SPECIFICATION
Replace seal.
Tighten the oil pressure switch -1- to 20 Nm.
LOWER OIL PAN, TIGHTENING SPECIFICATIONS AND SEQUENCE
Tight the lower oil pan bolts -1- in 3 stages as follows
| Stage | Tightening Specifications |
|---|---|
| 1. | Install all the way in by hand. |
| 2. | 5 Nm in a diagonal sequence |
| 3. | 9 Nm in a diagonal sequence |
UPPER OIL PAN, TIGHTENING SPECIFICATIONS AND SEQUENCE
Note. Replace bolts that are tightened to the specification.
Tighten bolts in 3 stages as follows
| Stage | Bolts | Tightening Specifications |
|---|---|---|
| 1. | 1 through 7 | Install all the way in by hand. |
| 2. | 1 through 7 | 5 Nm in a diagonal sequence |
| 3. | 1 through 7 | In a diagonal sequence, turn an additional 90° |