SPECIAL TOOLS AND WORKSHOP EQUIPMENT REQUIRED
- Hose Clamps Up to 25 mm Dia.3094
- Torque Wrench 5-50 Nm V.A.G 1331
- Spanner Wrench3212
- Torx® Socket T60 T40087
- Used Oil Collection and Extraction Device V.A.G 1782
- Spring Type Clip Pliers VAS 5024 A
- Bit reversible ratchet with a bit insert (commercially available)
- Hydraulic fluid
General Information
Vane pump is not designed to be serviced. If there are customer complaints, the cause must be determined using a pressure and leak test. If there is a malfunction, replace the vane pump.
- If fluid is low in reservoir, always check steering system for leaks.
- If there are leaks in the area of the line connections, the lines/connections must first be inspected for leaks, tightened as necessary and wiped dry.
- Pump is delivered without oil. Therefore, hydraulic oil must be filled before installation and turned by hand. Otherwise, noises when driving or damage to pump may occur.