Dimension -a- = same on both sides (left and right)
Dimension -b- from top of bumper cut-out to tailpipe must be at least 20 mm (0.7 in.).
Contents
Wiring diagrams Section: Exhaust- Exhaust System, Servicing
- Removing and Installing
- Installing
- Front Exhaust Pipe with Three Way Catalytic (twc) Converter (left Side), Removing and Installing
- Align Exhaust System to Avoid Stress in the System and to Prevent Noise as Follows
- Installation Position of Double Clamps Between Catalytic Converters and Center Muffler
- Tailpipes, Aligning
- Rear Mufflers, Aligning
- Installation Position of Rear Double Clamps
- Exhaust System, Checking for Leaks
- Abbreviations
- Airbag
- Anti-Lock/traction Control
- Application
- Automatic HVAC System
- Automatic Trans
- Axle Shafts
- Basic Trouble Shooting
- Brakes
- Cabin Air Filter
- Charging System
- Check Lists
- Collision/avoidance
- Communication Devices
- Cooling Fan
- Cruise Control Systems
- Diagnostic Connector Locations
- Door Locks & Anti-Theft Systems
- Drive Cycles
- Driveline/axles
- DTC Index
- Electrical
- Electronic Steering
- Electronic Suspension
- Emission Applications
- Engine
- Engine Performance
- Exhaust
- Exterior Body Panels
- Fuel System
- Fuses & Circuit Breakers
- Gauges & Instrument Panels
- Heated Glass/defoggers
- Identification
- Ignition System
- MAP Guidelines
- Mechanical
- Mechanical - Hydraulic
- Metric Conversions
- Mirrors
- Mode 6
- Oem General Information
- Procedures
- Reset Procedures
- Restraints
- Seats
- Specifications
- Starter
- Steering
- Steering Column Switches
- Sun Roof/t-Top/convertible Top
- Suspension Front
- Suspension Rear
- Testing & Diagnostics
- Timing Belt
- Traction Control Disable
- Transmission
- Warning System
- Wheel & Tire System
- Wheel Alignment
- Windows
- Wiper/washer Systems
