Home ReviewsRefund
Home/Audi/A6/Audi A6 C5 facelift (2001-2004)/Repair manual/3.0L V6 (Engine Code: Avk)/Harmonic balancer, removing and installing
Contents Wiring diagrams Section: 3.0L V6 (Engine Code: Avk) All sections

Harmonic balancer, removing and installing Audi A6 C5 facelift

3.0L V6 (Engine Code: Avk) 1 illustration ~125 words

Harmonic balancer, removing and installing

  1. Lock carrier in service position (see «LOCK CARRIER, MOVING INTO SERVICE POSITION»(ref-196254-S41599485202005100700000) ).
  2. Ribbed belt removed (see «RIBBED BELT, REMOVING AND INSTALLING»(ref-196254-S34290437782005100700000) ).
  1. Remove 8 bolts -1-.
  2. Remove harmonic balancer -2- and thrust washer -3-.

Note. Thrust washer -3- is only installed on toothed belt gear with part number 06C 105 063.-No thrust washer must be installed for toothed belt gear with part number 06C 105 063 B.

Scheme 359

Scheme 359
Scheme 359

Installation is reverse of removal, noting the following

  1. Insert thrust washer in such a way that the convex edge points toward the harmonic balancer.
  2. When installing the harmonic balancer, make sure notches (arrows) in harmonic balancer are aligned with locating lugs on toothed belt sprocket.