- Before installing the bumper, ensure the expanding clips are pressed into the fender. (Схема №12) When installing the tabs, the bumper cover must latch into clip (4). (Схема №13)
- Latch bumper cover (1) into guide (2). (Схема №13) Tighten flange nuts (10) to 53 INCH lbs. (6 N.m).
- Screw in socket-head bolts (7) and tighten to 17 ft. lbs. (23 N.m). (Схема №13)
Contents
Wiring diagrams Section: Cooling System (mechanical)- Engine Code
- Draining & Filling
- Coolant Recommendations
- Removal (A6)
- Installation (A6)
- Thermostat
- Removal & Installation
- Water Pump
- Torque Specifications
- Abbreviations
- Airbag
- Anti-Lock/traction Control
- Application
- Automatic HVAC System
- Automatic Trans
- Axle Shafts
- Basic Trouble Shooting
- Brakes
- Cabin Air Filter
- Charging System
- Check Lists
- Clutches Manual & Hydraulic
- Communication Devices
- Computer Relearn
- Cooling System (mechanical)
- Cruise Control Systems
- Diagnostic Connector Locations
- Differentials & Drive Axles
- Door Locks & Anti-Theft Systems
- Drive Cycles
- Driveline/axles
- DTC Index
- Electrical
- Electrical Component Locations
- Electronic Suspension
- Emission Applications
- Engine
- Engine Performance
- Exhaust
- Exterior Body Panels
- Exterior/interior Trim
- Fuel System
- Fuses & Circuit Breakers
- Gauges & Instrument Panels
- General Servicing - All Makes
- Heated Glass/defoggers
- Identification
- Ignition System
- Manual Trans
- MAP Guidelines
- Mechanical
- Mechanical - Hydraulic
- Metric Conversions
- Mirrors
- Mode 6
- Oem General Information
- Procedures
- Reset Procedures
- Restraints
- Seats
- Specifications
- Starter
- Steering
- Steering Column Switches
- Sun Roof/t-Top/convertible Top
- Suspension Front
- Suspension Rear
- Testing & Diagnostics
- Timing Belt
- Traction Control Disable
- Transmission
- Warning System
- Wheel Alignment
- Windows
- Wiper/washer Systems