BRACKET
Special tools and workshop equipment required
- Special Pop Rivet Pliers V.A.G 1753A
- Drill
- Protective Eyewear
Scheme 309
Remove center armrest. Refer to CENTER ARMREST .
Remove the backrest trim (if necessary). Refer to BACKREST TRIM .
Remove the backrest cover. Refer to BACKREST COVER .
Note. Place plastic film between the bench seat and backrest to protect against metal shavings.
| WARNING | Risk of injury! Wear protective eyewear. |
Drill out rivet -3-.
Remove the nuts -4- (quantity: 2).
Remove the bracket -1- from the threaded pins -5- and pull it out of the profile -2- in the direction of the -arrow-.
Install in reverse order of removal.
Scheme 310
Fold up center armrest -2- to 2 / 3 .
Remove the bolts -arrows- (quantity: 4).
Remove the center armrest from the storage compartment -1-.
Install in reverse order of removal.
Scheme 311
Fold up center armrest -1- to 2 / 3 .
Remove the bolts -arrows-.
Remove center armrest -1- from pass-through cover -2-.
Install in reverse order of removal.
Scheme 312
Fold center armrest up.
Open the lid -1- for the pass through cover.
Remove the bolts -arrows-.
Remove the center armrest with the pass-through cover.
Install in reverse order of removal.
Scheme 313
Note. The backrest only needs to be disengaged from the mounts to remove and install the center bracket. The release cables in the connector stations must not be disconnected.
Remove the seat bench. Refer to BENCH SEAT .
Remove the right 2/3 section of the backrest. Refer to BACKREST .
Remove the left 1/3 section of the backrest. Refer to BACKREST .
Remove bolts -1- (quantity: 4).
Remove the center bracket -2- from the vehicle floor -3-.
Install in reverse order of removal.
Scheme 314
Remove the seat bench. Refer to BENCH SEAT .
Disengage the molding -2- from the channel -arrow- in the center storage compartment -1- at the rear and both sides.
Unclip the center storage compartment -2- at the seat frame -1- -arrows-.
Scheme 315
Pull the center storage compartment forward and disengage the tabs at seat frame -1-.
Remove the center storage compartment from the seat frame.
Install in reverse order of removal. Note the following
When installing, make sure all the tabs slide onto the seat frame and the center storage compartment engages completely.
When engaging the cover in the center storage compartment channel, begin at the center of the rear.
Align the cover molding to the center storage compartment and then clip the cover into the center storage compartment channel.
Do the same on the other sides of the cover.
Make sure the covers are secured on the center storage compartment without wrinkles.