Recommended mixing rations for 8 liter (8.4 qt.) capacity, see COOLANT FILLING RECOMMENDATIONS .
| Frost Protection | J 011 A8B or C | Water |
|---|---|---|
| -25° C (-13° F) | 3.2L (3.4 qt.) | 4.8L (5.1 qt.) |
| -35° C (-31° F) (1) | 4.0L (4.2 qt) | 4.0L (4.2 qt) |
| (1) For cold climates | ||
| (1) | For cold climates |
COOLANT FILLING RECOMMENDATIONS
- back off each of two bleed screw approx. 2 turns. In coolant hose to heater core, right, next to brake booster Bleed screw in large coolant pipe, next to engine coolant temperature sensor. See «COOLANT PIPES, LAYOUT»(ref-201030-S31020318262005102400000) .
- Pour coolant into expansion tank.
- Check bleed screws and close when coolant starts to run out.
- Fill expansion tank until level reaches top edge.
- Install cap on expansion tank.
- Run engine at idle until coolant fan has switched on once.
- Increase engine speed to 2000 RPM for approx. 30 seconds.
- Stop engine (switch ignition off).
- Check coolant level in expansion tank and top up to MAX mark if necessary.