Home ReviewsRefund
Home/Acura/RL/Acura RL II facelift (2008-2012)/Repair manual/Testing & Diagnostics/DTC P0125: ECT Sensor 1 Malfunction/Slow Response
Contents Wiring diagrams Section: Testing & Diagnostics All sections

DTC P0125: ECT Sensor 1 Malfunction/Slow Response Acura RL II facelift

Testing & Diagnostics ~353 words

Note. Before you troubleshoot, record all freeze data and any on-board snapshot, and review the general troubleshooting information (see GENERAL TROUBLESHOOTING INFORMATION ).

  1. Start the engine, and let it idle 5 minutes or more.
  2. Check ECT SENSOR 1 in the DATA LIST with the HDS. Is about 10°F(-12°C) or less, or 4.45 V or more indicated? YES -Check for poor connections or loose terminals at ECT sensor 1, ECT sensor 2, and the PCM. If they are OK, replace ECT sensor 1 (see «ECT SENSOR 1 REPLACEMENT»(ref-348508-S25200254742009112400000) ). NO -Go to step 3.
  3. Turn the ignition switch to LOCK (0).
  4. Allow the engine to cool to 104°F (40°C) or less.
  5. Make sure the temperature difference between ECT SENSOR 1 and ECT SENSOR 2 is about 50°F (10°C) in the DATA LIST with the HDS.
  6. Start the engine, and let it idle until ECT sensor 1 goes up to around 158°F (70°C). Does ECT sensor 2 also show about 158°F (70°C)? YES -Go to step 7. NO -Intermittent failure, the system is OK at this time. Check for poor connections or loose terminals at ECT sensor 1, ECT sensor 2, and the PCM.
  7. Check the thermostat (see «FAN MOTOR TEST»(ref-348514-S30761986832009112400000) ). Is the thermostat OK? YES -Check for poor connections or loose terminals at ECT sensor 1, ECT sensor 2, and the PCM. If they are OK, replace ECT sensor 1 (see «ECT SENSOR 1 REPLACEMENT»(ref-348508-S25200254742009112400000) ), then go to step 8. NO -Replace the thermostat (see «THERMOSTAT REPLACEMENT»(ref-348514-S40460016632009112400000) ), then go to step 8.
  8. Turn the ignition switch to ON (II).
  9. Reset the PCM with the HDS.
  10. Turn the ignition switch to LOCK (0).
  11. Allow the engine to cool to 104°F (40°C) or less.
  12. Make sure the temperature difference between ECT SENSOR 1 and ECT SENSOR 2 is about 50°F (10°C) in the DATA LIST with the HDS.
  13. Start the engine, and let it idle until ECT sensor 1 goes up to around 158°F (70°C). Does the ECT sensor 2 also show about 158°F (70°C)? YES -Go to step 1 and recheck. NO -Troubleshooting is complete.

More articles — Pgm-Fi System