REMOVING ENGINE COMPARTMENT COMPONENTS
Ignition off.
Remove the air cleaner housing ACL assembly with the intake pipe. Pull the air cleaner (ACL) housing out of its mountings.
Remove
- the screws from the bracket for the gear selector cable
- the cable from the lever. Use special tool «9997077»(ref-460875-S05662014872012033000000) . Move the cable to one side.
Scheme 244
Remove
- the lever
- the nut, lock washer and rubber seal from the gear-shift position sensor
- the 2 screws for the gear-shift position sensor.
Carefully lift the sensor off the gear shift linkage rod.
Note. For tightening torques, see TIGHTENING TORQUE .
Scheme 245
Remove the old sealing ring. Use a small rounded off screwdriver.
Take care not to damage the rod.
Smear a little automatic transmission fluid on the new sealing ring. Install the ring. Use drift 9995476 .