INSTALLING ENGINE BLOCK COMPONENTS
Note. Always use new seal washers and gaskets
Install
- thermostat housing (B52x4x)
- knock sensor (KS)
- flame trap
- the pipe screw for the water-heated crankcase ventilation.
| B5xx4x ........ See ENGINE BODY, EXPOSING |
|---|
| B6xx4x ........ See ENGINE BODY, EXPOSING |
IF IN DOUBT ABOUT THE ORDER OF ASSEMBLY SEE
Install the flywheel and carrier plate. See CRANKSHAFT SEAL REAR, REPLACING .
| B5xx4x ........ See TIGHTENING TORQUE |
|---|
| B6xx4x ........ See TIGHTENING TORQUE |
FOR THE CORRECT TIGHTENING TORQUES SEE
The ignition coil alignment and the wiring routing follows the illustrations below.
