Signal Specification
See Signal specification
Component Specifications
The component specification gives the value of the component when the connector is disconnected. Where no value is given, it is not possible to measure a relevant value at the component.
The figure within the brackets indicates the terminal pin on the component to which the value refers.
| Designation | Type | Supply voltage | Value | Other |
|---|---|---|---|---|
| Acceleration sensor suspension, left and right-side front | 5V (#5) | Output signal (terminal #1) 0.5V - 4.5V | Resistance readings cannot be taken | |
| Position sensor suspension, left and right sides rear | 5V (#5) | Output signal (terminal #1) 0.5V - 4.5V | Resistance readings cannot be taken | |
| Acceleration sensor body | 5V (#5) | Output signal (terminal #1) 0.5V - 4.5V | Resistance readings cannot be taken | |
| Keypad | 5V | |||
| Shock absorber solenoids | U bat (#1) | Pulse width modulated (PWM) signal | Approximately 5 ohms(terminals #1-#2) |
See Component specifications