Home/Volvo/V70/Volvo V70 II рестайлинг (2004-2007)/Repair manual/Interior Equipment - Removal, Replacement and Installation/Installing front collision sensor

Contents

Section: Interior Equipment - Removal, Replacement and Installation

Dashboard, replacing

Removing dashboard

Installing dashboard

Installing steering column covers

Replacing steering column covers

Removing center tunnel console

Installing center tunnel console

Replacing front and rear box

Replacing handset

Installing handle (Applies only to V70XC)

Cup holder, replacing

Glove compartment, replacing

Backrest catches

Sun blind snap fastener

Installing table

Cushion upholstery

Center console, replacing

Transferring components

Installing center console

Integrated cargo net

Removing center console

Removing center storage compartment

Routing and securing cable

Installing center storage compartment

Connecting connector and installing tape

Sun visor, replacing

Table, replacing

Ashtray rear, replacing

Installing rear ashtray

Center console compartment middle, replacing

Installing center console compartment

Cover/armrest tunnel, replacing

Installing cover / armrest

Mug holder center armrest rear seat, replacing

Removing mug holder

Center arm rest/integrated child seat

Gear selector panel/boot, replacing

Installing gear selector panel

Side panel upper center console, replacing

Installing upper side panel, center console

Panel boot gear selector, replacing

Preparatory work

Airbag driver's side (SRS), replacing (3 spoke steering wheel)

Installing driver's airbag (SRS)

Removing battery lead and important information

Removing driver's airbag (SRS)

Adjusting steering wheel

Airbag driver's side (SRS), replacing (4 spoke steering wheel)

Airbag module seat (SIPS), replacing

Removing seat airbag modules (SIPS)

Airbag passenger (SRS), replacing

Installing passenger side airbag (SRS)

Preparations

Removing contact reel

Installing contact reel

End mounting, replacing

Installing front end mountings

IC (inflatable curtain) module, replacing

Deployed inflatable curtain module

Preparation

Installing seat belt buckle

Installing seat belt

Cargo compartment side panel (Auxiliary rear facing seat)

Cantrail panel

Removing seat belts from front seats

Installing seat belts for front seats

Removing rear seat belt buckle

Installing Front seat belt

Installing Rear seat belts

Installing Front seat belt buckle

Installing Rear seat belt buckle

Parcel shelf

Supplemental restraint system module (SRS)

Ordering software

Programming control module

Collision sensor front, replacing

Installing front collision sensor

Finishing

Collision sensor, replacing

Contact reel / steering wheel angle sensor, replacing

Force limiter mechanical/belt tension sensor, replacing

Important information

Adjusting seat position

Installing force limiter/belt tension sensor

Checking seat belt function and supplementary restraint system

Seat belt function, check

Seat belt buckles, auxiliary rear facing seat, replacing

Seat belts, auxiliary rear facing seat, replacing

Seat belts, replacing

Seatbelt force limiter adaptive, replacing

Installing adaptive seatbelt force limiter

Stop button, seat belt, replacing

All sections

Installing front collision sensor Volvo V70 II рестайлинг

Interior Equipment - Removal, Replacement and Installation

Installing front collision sensor

Install

the connectors, 1 on each collision sensor
the 2 x collision sensors. Use 2 x M6 screws on each collision sensor. Tighten. See: «Summary of tightening torques for specific components»(ref-407026-S27015769872011070100000) .

Note. Ensure that the collision sensor locating pins are aligned correctly against the cross member.