Home/Volvo/S60/Volvo S60 I рестайлинг (2004-2009)/Repair manual/Engine - Overhaul, Tightening Torques/Classification marking

Contents

Section: Engine - Overhaul, Tightening Torques

Cleaning

Selecting bearings

Removing the screwed joint from the intermediate section

Removing the piston cooling valve and nozzles

New connecting rod

Checking the connecting rod in a connecting rod aligner

Installing the piston cooling valve and nozzles

Classification of main bearings

Applying liquid gasket

Marking the connecting rod (where applicable)

Installing piston rings

Installing the pistons in the cylinder bores

Installing the oil pump suction pipe

Installing the sump

Installing the rear crankshaft seal

Removing the suction pipe from the oil pump

Checking markings

Removing the pistons from the cylinder block

Intermediate part

Installing the oil pan

Installing the oil cooler and oil filter

Removing the oil filter and oil pan

Separating the intermediate section from the cylinder block

Measuring the crankshaft

Check the out-of-true of the crankshaft

Removing the piston rings

Checking the axial clearance of the piston rings

Calculating the running clearance of the piston

Checking the bearing recess in the connecting rod big end

Measuring the cylinder bore

Classification marking

Cylinder block, measurement

Checking for wear

Installing the cylinder head

Adjusting the valve clearance

Installing tappets and camshafts

Measuring and reconditioning the cylinder head

Removing the cylinder head

Removing tappets

Removing valves

Removing valve stem seals

Checking the cylinder head

Checking for wear in the valve guides

Installing valve stem seals

Installing the valve / valve springs

Cylinder head, installing

Aligning the crankshaft

Installing valve lifters and camshafts

Installing the rear camshaft seal

Securing the camshafts

Cylinder head, removing

Removing the camshaft cover

Removing valve lifters from the cylinder head

Checking the vertical position of the valve stem

Installing valve springs

Installing front crankshaft seal

Installing the timing gear pulley for the camshafts

Finishing

Checking the markings and belt tension

Belt drive, dismantling

Removing the oil pump

Removing the thermostat and thermostat housing

Installing the water pump

Installing the crankshaft timing gear pulley

Checking and adjusting the variable valve timing unit

Dismantling the belt transmission

Removing the crankshaft pulley

Removing the belt tensioner and idler pulley

Removing the coolant pump / timing belt cover

Checking the opening function of the thermostat

Installing the oil pump

Installing the idler pulley and belt tensioner

Engine block, installing components

Installing engine block components

Engine body, exposing

Removing the gearbox

Sealing micro-enclosed screws

Exposing the engine body

Removing the transmission

Removing the flywheel / carrier plate

Removing the flywheel and carrier plate

Installing the variable valve timing (VVT) unit on the intake camshaft

Installing the timing belt

Adjusting the timing belt

Removing the timing belt

Removing oil pump

Checking the oil pump

Caulking

Pore preparation

All sections

Classification marking Volvo S60 I рестайлинг

Engine - Overhaul, Tightening Torques

Classification marking

Each cylinder is stamped with a classification letter (C, D or E) at the rear edge of the cylinder block.

Cylinder bore diameter: See Specifications, mechanical .