CD CHANGER
Special tools and workshop equipment required
- Radio Removal Tool 3316
Radio Removal Tool 3316 is made up of two identical parts.
Note. The CD changer is not faulty if the CD changer plays commercially available CDs, but not self-burned CDs. Replacing the CD changer for this reason is not permitted. Mixed CDs (CDs that contain computer data and also music) cannot be played. Music CDs with 8 cm diameter (mini-discs) cannot be played back. When retrofitting CD changer, radio functions must always be coded again.
Removal
Do the following before starting the procedure
If necessary, remove CDs remaining in CD changer. Refer to the Owner's Manual.
Turn off the ignition and all electric consumers and remove the key.
Open center armrest lid.
Slide 3316 into slots designed for them on CD changer at left and right -arrows- until they engage audibly.
Scheme 52
Pull out CD-changer using radio removal tools -arrows-.
Scheme 53
Disengage harness connector at points designated with -arrows- and disconnect it.
Scheme 54
Press on retaining clamp -arrow- and pull out radio removal tools from removed unit.
Scheme 55
Installation
Install in reverse order of removal.