Home ReviewsRefund Car not listed?
Home/Volkswagen/Eos/Volkswagen Eos I (2006-2011)/Repair manual/2.0L - Multiport Fuel Injection - Engine Code(s): Bpy/Throttle Valve Control Module -J338
Contents Wiring diagrams Section: 2.0L - Multiport Fuel Injection - Engine Code(s): Bpy All sections

Throttle Valve Control Module -J338 Volkswagen Eos I

2.0L - Multiport Fuel Injection - Engine Code(s): Bpy 2 illustrations ~143 words

Throttle Valve Control Module -J338

Removing

Remove the engine cover/upper air filter housing. Refer to ENGINE COVER/UPPER AIR FILTER HOUSING .

GTI

Remove the pipe -A- and hose -B- -arrows-.

Scheme 77

Scheme 77: Throttle Valve Control Module -J338
Scheme 77: Throttle Valve Control Module -J338

Continuation for all Vehicles

Loosen the hose clamp -1-.

Scheme 78

Scheme 78
Scheme 78

Remove the bolt -2-.

Remove the noise insulation. Refer to Description and Operation .

Disconnect the connector -3-.

Remove the bolt -4-, pull the charge air pipe off the charge air cooler and remove it downward.

Remove the four bolts for the throttle valve control module -J338- and remove it.

Installing

Install in reverse order of removal. Note the following

If a new throttle valve control module was installed, adapt the Engine Control Module (ECM) to the throttle valve control module. Refer to "Guided Functions" in the vehicle diagnosis, testing and information system VAS 5051.