Home/Toyota/Tundra/Toyota Tundra I (2000-2002)/Repair manual/Differentials & Drive Axles/Differentials - Automatic Disconnecting: Removal & Installa…

Contents

Wiring diagrams Section: Differentials & Drive Axles

All sections

Differentials - Automatic Disconnecting: Removal & Installation Toyota Tundra I

Differentials & Drive Axles ~130 words

Removal & Installation

ADD relay is located on right fender apron under hood. Use illustrations for locating ADD relay. (Схема №1), (Схема №3) or (Схема №4).

Disconnect electrical connector from L4 position switch located on transfer case. Unscrew L4 position switch from transfer case. Remove gasket from L4 position switch and discard.
To install, reverse removal procedure using NEW gasket. Tighten L4 position switch to specification. See «TORQUE SPECIFICATIONS»(ref-131893-S39316280002001122600000) . Reinstall electrical connector.

Disconnect electrical connector from 4WD position switch, located on transfer case. (Схема №1)- (Схема №4). Unscrew 4WD position switch from transfer case. Remove gasket from 4WD position switch and discard.
To install, reverse removal procedure using NEW gasket. Tighten 4WD position switch to specification. See «TORQUE SPECIFICATIONS»(ref-131893-S39316280002001122600000). Reinstall electrical connector.